Blog

Zips - Most sleeping bags are fitted with a full-length zip that runs the length of the bag almost to the foot. These zips usually have a slider at each end, allowing you to ventilate the bag from the foot end if it's too warm for the conditions.

Some manufacturers make bags with zips on either the left or the right-hand side. A left-hand zip is by your left hand as you lie in the bag on your back. A left-hand zip is suited to a right-handed person as the right arm comes across the body to unzip it, whereas using the left hand to unzip a left-handed zip would be trickier. Some manufacturers only make bags with left-hand zips.

Some bags don't have any zip at all to save weight, these are difficult to get in and out of. Some bags have a short zip on the side or top of the bag - again this feature saves weight. Access in and out of the bag is fine but it does not give any options to vent the bag at the bottom.

Recently we have seen full length zips set slightly on the top of the bag rather than on the side - these seem easier to use.

Baffles - Where there is a zip this is a potential cold spot, so, apart from very lightweight bags designed for summer use, most zips are insulated using a baffle - this is a down filled strip which sits across the zip eliminating it as a cold spot. Some higher spec bags have a double zip baffle.

Sleeping bags intended for use in colder conditions will also have a shoulder baffle, this enables you to fasten the bag around your shoulders without necessarily closing up the hood. This prevents draughts and stops air circulating out of the bag taking the warmth with it.

Quilting Methods - This refers to how the down compartments are constructed. Compartments are needed to keep the down in place, otherwise it would all migrate to the bottom of the bag.

• Sewn through - the simplest method where lines of stitching are sewn to join two fabrics together creating long pockets for the down to be fed into. The pinch points at the stitching prevent the down from lofting fully in these areas and there are potential cold spots along the stitch lines where there is no down.
• Box Wall Construction - overcomes the disadvantages of sewn through by stitching a third piece of material between each layer of fabric to create 'pockets' for the down, with walls. This eliminates pinching of the down at the stitch lines and allows the down to loft fully.
• Differential Cut - refers to the method of box-walling where the inner fabric is cut smaller than the outer shell, this is a more natural cut that stops bunching of material inside the bag and if the method used by quality manufacturers.
• Differential Fill - Refers to the practice of putting more of the down on top of the bag and less on the bottom. Since the bottom down is crushed anyway you are relying on your sleeping mat to keep you warm, Differential Fill makes best use of the down in the bag.
• Continuous Baffles - refer to the construction method where the baffles run across the bag and are 'continuous' from the top to the bottom of the bag. This means you can shuffle down from the top of the bag to the bottom and vice versa. Its claimed that you can therefore make a bag warmer or colder - but in practice the method is fiddly.